forum cleats for deck plank install

  • Speed of installation and cost are important, but so is long-term performance.


  • Next mark off all the deck beams, so when you're cover in plywood, you can put fasteners into these. With the fasteners checked and repairs to the old deck made, you can now toss down the plywood. Two layers of 1/4" (6 mm) will be much easier to bend to the deck crown, but one layer of 1/2" is all you need. Put this down in a bedding compound, thickened epoxy or over felt. Once the plywood is down, has screws into each deck beam and also into the old planking,& ...


  • There is a lot of "how-to's" when installing the cam cleat on a deck, but not a lot with regards to installing on a mast. I am using the 438 Cam-Matic Adapter Plate, which (looking at the install instructions) appears to be attached to the mast via a screw. Then, following the general instructions for the cam cleat, screws are then used to attach the cam cleat (to the adapter plate) and into the mast. What kind of screws am I supposed to use? I have never had to "screw"& ...


  • Has anyone used the Camo Fastener system in either composite or cedar? I heard tell that the screws can shear off due to board movement but that does not seem resonable if face screwing wouldn't do the same thing. www.camofasteners.com/ They are less expensive than most othe fasteners and look like they might not take as much time to install. Tags: None& ...


  • decking is essentially flooring so why not install it using a pneumatic flooring nailer? You can now with the HIDfast decking ... Some people who haven't used the HIDfast system express concern about how securely the cleats hold deck boards down. I recently had to remove a board during installation that was upside down; my 16 inch flat bar didn't have enough leverage to lift the deck board off the 11 joists it was nailed down to. Many other hidden fastener systems& ...


  • for lumber decking, the moisture content of the lumber and the environment its installed in matter. “Green” lumber, with a moisture content of more than 19% can be installed with nearly no gaps in arid environments and in a few short months will shrink to a desired size gap. Overall, conventional decking profiles should be installed such that when seasoned, will have gaps between 1/8 and 1/4 of an inch. Look at the ends of the boards and install the decking "barkside" up to prevent& ...


  • Currently installing pressure treated stair stringers and from past experience, metal hangers have been used to fasten the stringers to the support joist/beam. In this case, the GC I work for had the metal ... My vote goes for the cleat and notched stringer although I would not be averse toward the proper hanger. The cleat would be screwed and glued. ... That's ok, I like them better than a cleat for PT lumber as it's generally Hemlock. Bad lumber, but easy to treat I guess.